SHANGHAI MICROCRE OPTICS-MECH TECH CO., LTDAbout MICROCRE400-812-7833
INDUSTRIES

Aerospace and high-temperature structural materials

For superalloys, lightweight alloys and coatings, connect processing state, thermal exposure and sampling location. Combine microstructure, local hardness and mechanical tests as complementary evidence, while distinguishing laboratory characterisation from component qualification and actual service conditions.

Theory & worked calculations

Item

Translation pending review.

高温加载杆:均匀温升的热膨胀量级:模型与量纲

Equation

Translation pending review.

ΔL=αL0ΔT;ΔL单位换算

Variables & dimensions

Translation pending review.

L0=80 mm;平均α=13 µm/(m·K);ΔT=500 K

Assumptions & limits

Translation pending review.

不包含材料相变、温度相关系数积分、弯曲、接头和约束。温度梯度下不能只把炉温设定值当全杆温度。

Worked example

Translation pending review.

假设输入演算:13×10⁻⁶×80×500 = 0.52 mm;0.52×1000 = 520 µm。量级估算显示热伸长可能远大于微小压入位移,解释了基准布局、隔热与稳定等待的重要性。它只能帮助设计误差预算,不证明现有仪器漂移为520 µm。

Reporting requirements

Translation pending review.

以试样编号关联原始图像、测量序列、设备配置及方法版本。

Translation pending review.

分别报告重复性、异常处理及本模型未覆盖的影响因素,不用演算示例替代实测。

Common misconceptions

Translation pending review.

炉温稳定不等于接触区温度准确或测量链无漂移;需独立定位温度与位移基准。

Translation pending review.

保持段位移可能同时包含真实变形与仪器漂移,不能把全部斜率直接扣除。

Workflow & steps

01

Build the specimen history

Record batch, heat treatment, coating process and service or simulated exposure. Identify whether the substrate, interface or surface is the target. Preserve sampling orientation and locations rather than pooling unlike regions.

02

Preserve structure and interfaces

Use low-damage sectioning and suitable mounting, checking coating edges, interface cracks and polishing relief. Tough alloys can retain machining deformation; progressive preparation and inspection establish whether it has been removed.

03

Link structure and local properties

Coordinate microscopy and indentation locations and record phases, pores and cracks. Near interfaces, assess neighbouring-phase and substrate effects; a mixed response should not be labelled an intrinsic single-phase hardness.

04

Match environment and loading

Choose ambient or elevated-temperature loading for the research question and record atmosphere, temperature path and time. Keep preparation and analysis consistent before and after exposure, checking oxidation and tip changes for comparability.

05

Report evidence and limits

Link micrographs, indents, curves and history by specimen ID; report repeatability and failure location. Service life, airworthiness and component safety require dedicated validation and cannot be inferred from a hardness test alone.

Checks

  • • Retain orientation and thermal history
  • • Separate interface response from phase properties
  • • Do not substitute characterisation for qualification

Illustrative example

Teaching example: compare coating cross-sections before and after thermal exposure and check interface effects on local hardness. No customer identity or aerospace certification is claimed.

Related instruments & resources

Links support navigation and do not establish a model’s performance or standards compliance.

Your next research question. Let’s explore.

Tell us about your material, specimen and measurement goal.

Discuss your application ↗
Find your instrument
⌕
Search products, cases, solutions, standards and literature.