SHANGHAI MICROCRE OPTICS-MECH TECH CO., LTDAbout MICROCRE400-812-7833
RESEARCH · INSTRUMENTS · MATERIALS

Simulation laboratory

Connect instrument principles, research objects, complete workflows and reproducible models using currently reviewed information.

215 records · All content ↗

GUIDED EXERCISES

Design exercises: think first, then measure

Six exercises connect models, calculations and preparation practice.

01

From a single value to a depth profile

Use hardness conversion and an indentation model to see why the same material reads differently at 50 µm and 500 µm.

  1. Compare HV0.1 and HV1 in the conversion tool and note the assumptions
  2. Reduce peak load tenfold in the indentation model and watch residual depth
  3. List three experimental reasons small loads read high

Conversion tables hold only for a comparable condition and near-isotropy; they do not replace a measured reference.

02

How long a guideway can an autocollimator cover

Estimate feasible segment length and accumulated error from angle and distance.

  1. Convert 0.1″ resolution into linear deviation over 500 mm
  2. Double the pitch and compare per-segment and accumulated error
  3. Explain why both ends need a closure check

More segments accumulate more reading error; choose the pitch against resolution and effort.

03

Cutting parameters and burn depth

Relate feed rate and cooling to damage depth for a preparation procedure.

  1. List three habits that worsen burning
  2. Design a control that changes only feed
  3. State two pieces of evidence that burning is excluded

High hardness is not automatically a material effect; exclude preparation hardening first.

04

Where tensile scatter comes from

Quantify specimen, grip and extensometer factors to decide whether more replicates are needed.

  1. Check how section area shifts strength in the stress tool
  2. List three grip problems causing early failure
  3. State the minimum conditions for valid data

Excluded data must be documented; never keep only favourable results.

05

Choosing dwell time for hot indentation

Understand creep effects on indent size and set a reproducible soak and dwell.

  1. Compare trends at 10 s and 30 s dwell
  2. Write a stability criterion such as drift within 5 minutes
  3. Explain why heating rate must be reported

Hot hardness is comparable only at a stated temperature, dwell and atmosphere.

06

How much error a threshold shift introduces

Compare phase fraction on one micrograph at different thresholds to see systematic bias.

  1. Three thresholds in one field, record phase fraction
  2. Explain how uneven illumination affects threshold choice
  3. List the minimum report metadata: magnification, threshold, field count

Image results depend on preparation and illumination; cross-lab comparison needs a shared procedure.

These exercises are educational. Parameters and conclusions explain methods only and are not performance claims for any material or instrument.

Your next research question. Let’s explore.

Tell us about your material, specimen and measurement goal.

Discuss your application ↗
Find your instrument
⌕
Search products, cases, solutions, standards and literature.